Pressure-resistant Seeflex 060ES is a clear, ether-based thermoplastic polyurethane alloy with an internal polyester scrim.
The internally bonded scrim restricts the Seeflex sleeve from stretching and provides superior pressure resistance.
Seeflex complies with the following regulations: FDA 21 CFR 177.1680 & 177.2600, USDA & 3A (20-), (EC) 1935/2004, 2023–2006 & 10/2011
The BFM® Seeflex 060ES connector is only used for overpressure situations for continuous pressure up to 1.3 bar (tested on a static 200mm diameter x 200mm long connector *)
IMPORTANT NOTE: Seeflex 060ES is designed to resist extremely high pressure and therefore it should not be used where the connector is intended to act as a pressure-release point.
* Engineering adjustments should be made for changes in diameter. For length adjustments or non-static applications, contact BFM®.
Diameters: Ø100mm (4"), Ø125mm (5"), Ø150mm (6") through to Ø1,650mm (65") in 50mm (2") increments
Lengths: 80mm (3"), 100mm (4") then in 50mm (2") increments up to 1,000mm (3ft 3")
NB: Some length restrictions apply for connectors over Ø650mm and diameter/length restrictions apply for those with Tool Release options. Refer to the Quick Reference Limitations Summary for more information.
Wall Thickness (+/- 10%) | 1.3mm (3/64 inch) |
Tensile Strength (MPa) | 47 |
Max. Operating Temp | 120ºC / 248ºF |
Low Temp Flexibility | Good |
Elongation (100%) | 12.5 |
Elongation (300%) | 16 |
Available Diameters | Ø100mm, 125mm then 150mm - 1,650mm (in 50mm increments) |
Weight | 1,220g/m2 / 43oz/yd2 |
Permeability | 0 |