Seeflex 020E

Yes, the silicone is post-cured which makes it food grade.

Yes – both CIP and manual washing is possible. Refer to the washing guidelines for Seeflex and Woven connectors.

Between 3 and 9 pH is generally acceptable, and outside this it is largely dependent on concentration, application and duration of contact. It’s important to remember that the pH scale alone doesn’t specifically help determining resistance of the materials – the pH scale will provide an indication of the strength, but product type, concentrations and temperatures are far more important. Our woven Teflex is an excellent alternative for use with acids or alkalis. This is a pure PTFE media which can be used on most products and up to very high temperatures. It is best to double check with us if there are any concerns regarding media compatibility.

It depends on the type of oil. Some oils are very aggressive and would degrade the polyurethane and the tight seal of the spigot connections can also be adversely affected by oils.

We have BFM^® fitting running with coffee in a number of plants around the world. There is no difference in terms of connector life than any other general application, it will depend on the conditions. There have been no problems with oils from coffee affecting the media.

No, 020E is the thinnest available.

Seeflex 040E, Seeflex 040AS, LM4, LM3 and TEFLEX can all be supplied with rings. Seeflex 020E may be supplied on request, but Camlon connectors, Kevlar covers and Blackout Covers, cannot be supplied with rings.

No – BFM® Global Ltd certifies that in the manufacturing of our products we do not intentionally use any of the below mentioned substances and it is not foreseen that they could be produced: Bisphenol-A (BPA) Bis (2-ethylhexy) phthalate (DEPH) Dibutyl Phthalate (DBP) Benzyl Butyl Phthalate (BBP). Refer to our Seeflex Safety Declaration for more information.

No, to the best of our knowledge, BFM^®'s material suppliers do not use or intentionally incorporate any of the following agents into the Seeflex 040E, 040As or 020E that we use for production of our connectors:

• Bisphenol-A (BPA)
• Bis (2-ethylhexy) phthalate (DEPH)
• Dibutyl Phthalate (DBP)
• Benzyl Butyl Phthalate (BBP) or any other Phthalates
• Cyanuric Acid
• Latex
• Melamine
• Nonylphenols
• Oleamide
• Silicone

Please refer to the Seeflex Materials Safety Declaration.

Yes, you can definitely reuse them - typically companies will use them until they start to show a little wear.

For standard Seeflex 040E connectors from 700mm (27.5 inches) to 1,000mm (39.5 inches) in diameter, a maximum length of 500mm (20 inches) applies. For connectors from 1,050mm (41 inches) up to the maximum of 1,650mm (65 inches) in diameter, a maximum length of 200mm (8 inches) applies. Under certain circumstances (and depending on the application) there may be a possibility for a slightly longer length, however, this would need to be discussed with BFM^®.  Refer to our Quick Ref. Limitations Summary here for more information.